Mt7201 Led Driver For Mac

Introduction

The MT7201 includes the output mt7201 led driver and a high-side output current sensing circuit, which uses an external resistor to set the nominal average output current. If I ground the Re11rmmw pdf pin on the drivers, the LED's go off as expected.

Use this guide to replace a broken LED driver board.

No parts specified.

Before beginning, unplug your iMac and lay it on a soft surface as shown.
Stick a suction cup near each of the two top corners of the glass panel.
To attach the suction cups we sell, first position the suction cup with the movable handle parallel to the face of the glass panel. While lightly holding the suction cup against the glass, raise the movable handle until it is parallel with the other handle.
If your suction cups refuse to stick, try cleaning both the glass panel and the suction cup with a mild solvent.

Gently lift the glass panel perpendicular to the face of the LCD enough to clear the steel mounting pins attached along the underside of the top edge of the glass panel.
Pull the glass panel away from the lower edge of the iMac and carefully set it aside.
During reinstallation, be sure to meticulously clean the inside of the glass panel and the face of the LCD as any dust or fingerprints trapped inside will be annoyingly visible when the machine is turned on.

Remove the eight 8 mm T10 Torx screws securing the display to the outer case.
The last two pictures are detail shots of each side of the display.

Slightly lift the top edge of the display out of the outer case.
Do not lift it too much. There are several cables attaching the display to the logic board.

Pull the vertical sync ribbon cable out of its socket on the LED driver board near the top left corner of your iMac.
The vertical sync ribbon cable has a ZIF style end, but the socket has no lock or retaining flap. Simply pull the cable away from its socket toward the optical drive side of the iMac to disconnect it from the LED driver board.

Rotate the display out of the outer case enough to disconnect the LED backlight power cable from the LED driver board.
Disconnect the LED backlight power cable by depressing the locking mechanism while pulling the connector away from its socket (toward the bottom edge of the iMac).

Squeeze the two display data cable connector arms together to unlock it from its socket on the logic board.
Pull the display data cable connector away from its socket on the logic board.
Be careful when disconnecting and reconnecting this cable, as it is easily damaged.

Disconnect the LCD thermal sensor cable connector from its socket on the logic board.
If your fan is spinning full speed after completion, check this connection or the hard drive's thermal sensor cable.

Carefully pull the display toward the top edge of your iMac and lift it out of the outer case, minding any cables that may get caught.

Remove the two 9 mm T10 Torx screws securing the LED driver board to the outer case.

Lift the LED driver board out of its recess in the outer case, minding the DC-In cable still attaching it to the power supply.
Disconnect the DC-In cable by depressing the locking mechanism while pulling the connector away from its socket on the LED driver board.

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview

Get ready for macOS Catalina

Experience dedicated apps for music, TV, and podcasts, plus smart new features like Sidecar.

Back up your Mac

And your memories. A few simple steps can save you from losing your favorite photos and files.

Learn how to back up your Mac

Mac service and repair

Learn about AppleCare+ and the Apple limited warranty coverage, start a service request for your Mac, and find out how to prepare your Mac for service.

Learn more about repairs

AppleCare+ for Mac

Buy AppleCare+ within the first 60 days of purchasing your new Mac. You get up to 3 years of accidental damage coverage and 24/7 expert technical support from Apple, the people who know your Mac best.